zmbaker06
zmbaker06
01-10-2021
Arts
contestada
What is Support in printmaking?
Respuesta :
perkins52306
perkins52306
01-10-2021
They are used to support parts of the model during printing. After printing, you remove them.
Answer Link
VER TODAS LAS RESPUESTAS ( 47+ )
Otras preguntas
An aquarium tank can hold 5400 liters of water. There are two pipes that can be used to fill the tank. The first pipe alone can fill the tank in 45 minutes. The
Calculate the length of the unknown side marked on the diagram (10.30, 4.9cm)
A constant force applied to object A causes it to accelerate at 6 m/s2. The same force applied to object B causes an acceleration of 3 m/s2. Applied to object
f(x)=2x-8 g(x)=x^(2) Find a value of x such that fg(x)=0.
find the volume of the cone shown below
HELPPPPPPPPPP PLEASEEEEEEEE!!!!!!
qouestions on networking
Write the balanced equation and determine the information requested. Don't worry about state symbols in these reactions. The number of moles and the mass (in mi
The height of a wall is five times its width ,and its length is eight times its height. If the volume of the wall is 12.8m³. Find its length
The perimeter of the triangle below is 41 units. Find the length of side AC. Write your answer without variables.
